Home > News > Content

Diamond Tool Manufacturing

Apr 04, 2021

The selection of raw materials and hot pressing process are the key points in the tool head manufacturing technique. Co - based and bronze - based alloy systems are widely used as raw materials for fetal body, but they cannot achieve a good balance in terms of manufacturing cost and use function. Fe-Ni-Cu-W alloy is put forward as the raw material of the tool head body through the analysis of the level.

The manufacturing process of diamond saw blade head can be described as the sintering process of metal powder under certain pressure, which is a powder metallurgy process: The uniform metal powder at high temperature (800-1000℃) and under certain pressure (180-250kgf /cm2), through the process of diffusion between powder particles, fusion welding, chemical combination, recrystallization and a series of physical and chemical leaching, the formation of a certain shape and machine function of the sintered body, that is, the knife head.

There should also be strict requirements on the raw material foundation of the saw blade head body:

1, sintered body should have excellent attack function and appropriate hardness, in order to ensure that the diamond wrapped by the formation of excellent machine meshing and moderate anti-wear means to the rock;

2. It can complete the powder metallurgy process to satisfy the above functional requirements within a relatively low sintering temperature (usually no more than 950℃) and a relatively short heat preservation time (generally no more than 5 minutes) to slow down the deterioration trend of diamond single crystal;

3. The alloy components in the fetal alloy can be brilliantly infiltrated into the single crystal of diamond, and the chemical bonding and impregnation between the alloy components and diamond can be produced through the process of microelements, so as to further improve the means of cheating the diamond.

By means of powder metallurgy, the fetal material can be alloyed with a similar structure to a common alloy. How many phases are there in the alloy structure, where the alloy tends to be the superior solid solution phase among the elements with similar electrochemical properties and atomic radii. Because the solid solution phase produces lattice distortion in the natural process, the resistance of the lattice dislocation movement increases greatly, so that the strength and hardness of the raw materials are improved, that is, the solid solution is generated to strengthen the impregnation, so that the solid solution phase becomes the most basic component phase of the raw materials with higher requirements for the comprehensive machine function. It can be said that the solid solution phase of fetal alloy is one of the keys to achieve high performance of fetal material.

According to the basic requirements of the raw material of the saw blade head body, the alloy system that is easy to form a solid solution phase in the body alloy and is bred to produce solid solution and strengthen the impregnation should be selected as the foundation factor of the body. Fe-Ni-Cu-W alloy system meets this requirement:

Fe-Ni and Cu-Ni can achieve complete intersolubility.

WC/W-Ni, WC-Cu and Fe-Cu can achieve limited intersolubility and can inoculate and produce dispersion enhanced impregnation.

Fe, Ni Ⅷ group elements have a wonderful affinity for diamond.

After the finished product, the tool head is installed on the substrate in a variety of different ways, and made into finished products by grinding and spraying paint, which is widely used in all kinds of life and production operations.


Send Inquiry